12 13
CHARGING THE BATTERY
1. Charge the unit before using the unit for the first time.
2. Do not charge the batteries near any flammable
substances.
3. Fully charge the batteries if the unit is to be stored
without use for a period of 3 months or more.
Recharge the Unit If:
• The LED indicator light on the receiver is emitting a
red color.
• The indicator light on the receiver will not come on.
The YS300 uses lithium-polymer batteries. The battery
charger is designed for a 120 volt wall outlet.
Note 1: Only use Dogtra-approved lithium polymer
batteries and chargers for your Dogtra unit. This will
prevent any damage that can be incurred from attempting
to use a different charger.
Note 2: The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the collar, be sure to give
it a full 2-hour initial charge before the first use. When a
charger is not in use, disconnect it from the power source.
Battery Charging Procedure
To Next Page
Loading...
