14 15
Proper Fit
The receiver should be fitted so that the surgical stainless
steel contact points press firmly against the dog’s skin. You
should be able to fit a finger in between the contact point
and your dog’s skin. The best location is on either side of
the dog’s windpipe.
Improper Fit
A loose fit can allow the collar to move around on the dog’s
neck. When this happens, the contact points may rub
against the skin and cause irritation. If the receiver is too
loose, the contact will not be consistent and cause the
corrections to be inconsistent. Dogtra uses surgical
stainless steel contact points and anti-microbial plastic to
protect the dog’s skin.
RECEIVER FITTING
1. Attach the charging cable to the receiver, as shown on
page 13.
2. Plug the charger into a 120 volt wall outlet or, if using the
auto charger, plug into a cigarette lighter only for lithium
polymer batteries (use a 230 volt European charger
for Europe). All indicator lights should glow red when
properly plugged in and the unit will automatically shut
off during the charging process. You will need to turn the
unit on again before use once the unit is fully charged
and unplugged from the battery cable.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will turn green once the unit is
fully charged.
4. After charging, cover the battery charging receptacle
with the rubber plug on the receiver.
To Next Page
Loading...
