Dolby Laboratories DP600 - Upgrading Licenses; Rebooting and Shutting Down

Upgrading Licenses
Dolby
®
DP600 Program Optimizer Manual 61
Althoughthetouchscreenwascalibratedduringthemanufacturingprocess,youmay 
needtorecalibrate.Ifthetouchscreencalibrationsetupappears,asshownin
Figure 3‐18,youneedtofollowstepsa–d,below,withinapproximately30seconds.
Ifyoudonotproceedwithinthistimeperiod,thecalibration
screendisappears.Ifthe
calibrationsetupdoesnotappear,proceeddirectlytostepd,tocompletetheupgrade
orcleaninstallation.
Figure3‐18 
Figure 3-18 Calibration Setup Screen
Asmalltargetappearsatonecornerofthecalibrationsetup,Tocalibratethetouch
screen:
a. Pressthefirsttargetforacoupleofsecondsuntilitchangestoacross.
b. Pressthenexttargetuntilitchangestoacross.
c. Continuethisprocedurefortheadditionaltargets.
Whenthecalibrationis
complete,ifyouperformedanupgrade,simplypage
throughthesetupscreenstodisplaytheDP600
Homescreen.Ifyouperformeda
cleaninstallation,theDP600Welcome!screenappears,providingachecklistof
thingsyouneedbeforeyoucanconfigurethesystem,asshowninFigure 2‐3.
d. Forcleaninstallations,youmustfollowthe instructionsinSection 2.2toconfigure
thesystem.
3.4 Upgrading Licenses
IfyouhaveanADMINIDandyouneedtoupgradeyoursystemforencoding,decoding,
transcodingandconversionorupmixing,seeUpgradingYourLicenseonpage 87.
3.5 Rebooting and Shutting Down
IfyouhaveanADMINIDandyouneedtorebootorshutdownthesystem,seeRebooting
andShuttingDowntheSystem onpage 94.
Send Us Your Feedback
Ifyouhaveaquestionoracommentregardingthischapter,sendusanemail.
Press target