Dolby Laboratories DP600 - System Administrator Functions; Access Levels; Admin Level; User Level

To Next Page

To Previous Page

Dolby

DP600 Program Optimizer Manual 79

Appendix C

System Administrator Functions

ThischapterisforDP600systemadministratorsonly.Beforeuserscanoperatethesystem,

asystemadministratormustsetupuserIDsandpasswords,whichspecifytherespective

accesslevelforeachuser.

C.1 Access Levels

TherearethreeDP600accesslevels:

•VIEWER (default):nopasswordrequired

• USER: password required

• ADMIN: passwordrequired

C.1.1 Admin Level

TheADMINlevelisintendedonlyforsystemadministrators.Withthislevelofaccess,a

systemadministratorcanperformallDP600functions.

C.1.2 User Level

TheUSERlevelisintendedforDP600operators.Userscanviewinformationandsystem

status,andsetupworkordersandgeneratereports,butcannotcanceloreditworkorders

orusethe

config,upgrade,maintenance,andpowerfunctions.

C.1.3 Viewer Level

AttheVIEWERlevel,ausercanviewinformationandsystemstatus,butcannotoperatethe

system.Thisisthedefaultlevelofaccessanddoesnotrequireapassword.

Note: YoucanchangetheVIEWERaccessleveltoUSERorADMIN,asdescribedin

ChangingtheDefaultAccessLevelonpage 83.

Other manuals for Dolby Laboratories DP600