To Next PageTo Next PageWhat to do if Dolmar ES-153 A has no chain lubrication?
If there is no chain lubrication in your Dolmar Chainsaw, the oil tank may be empty. Refill the oil tank. Also, the oil guide groove may be dirty, so clean the oil guide groove.
What to do if my Dolmar ES-153 A does not work, has insufficient performance, and no chain lubrication?
If your Dolmar Chainsaw isn't working, has poor performance, and the chain isn't being lubricated, first check the power supply and cable for any defects. Replace the mains fuse if necessary. Inspect the carbon brushes for wear. Also, ensure that you add oil to the oil tank.
What to do if my Dolmar Chainsaw does not work?
If your Dolmar Chainsaw isn't working, begin by checking the supply cable and power source, as the issue might be due to no power supply or a defective cable. Also, examine the mains fuse and replace it if it's blown. Finally, check the carbon brushes and replace them if they are worn down.
Why Dolmar Chainsaw has insufficient performance?
If your Dolmar Chainsaw shows insufficient performance, it may be due to low pulling power. Check the saw chain and oil tank for any dirt or blockages. Also, check if the oil tank is empty or the oil guide groove is dirty. If so, refill the oil tank and clean the oil guide groove.
What causes chain brake problems in Dolmar Chainsaw?
Chain brake problems in your Dolmar Chainsaw can be caused by a brake band worn down or the chain brake being actuated. Inspect the brake band and replace it if necessary.
General
