Why Dolmar Chain saws engine starts, but dies immediately?
Your Dolmar Chain saws engine might start but then immediately die due to several potential issues: incorrect idling adjustment, a dirty suction head or carburetor, a defective tank venting system, an interrupted fuel line, a defective cable, or a defective combination switch.
Why Dolmar Chain saws has insufficient power?
Insufficient power in your Dolmar Chain saws could be due to a dirty air filter, incorrect carburetor adjustment, a clogged muffler, a clogged exhaust channel in the cylinder, or a clogged spark arrester screen.
Why Dolmar Chain saws engine does not start or only with difficulty?
Your Dolmar Chain saws engine may not start or may start with difficulty due to a malfunction in the fuel supply system, compression system, or a mechanical malfunction. Other potential causes include the STOP switch being in the 'on' position, a fault or short-circuit in the wiring, a defective spark plug cap or spark plug, the combination switch being in the Choke position, a defective carburetor, a dirty suction head, a bent or interrupted fuel line, a defective cylinder base packing ring or radial shaft packings, defective cylinder or piston rings, a spark plug that does not seal, a broken spring in the starter, or broken parts inside the engine.
What to do if Dolmar Chain saws has no chain lubrication?
If your Dolmar Chain saws is not lubricating the chain, check if the oil tank is empty, the oil guide groove is dirty, or the oil pump adjusting screw is incorrectly adjusted.
Why Dolmar Chain saws has warm start difficulties?
Warm start difficulties with your Dolmar Chain saws may be caused by a wrong carburetor adjustment.
Details on warranty coverage, covered parts, and how to obtain service for emissions components.
Guidelines for maintenance required for warranty and the process for making a warranty claim.
Essential safety rules and warnings for chain saw operators during use.
Further safety measures to be observed by all chain saw users.
Requirements for the operator's physical and mental fitness to safely operate the saw.
Detailed instructions on how to safely refuel the chain saw with the correct fuel mixture.
Definition and causes of kickback, a dangerous reactive force.
Identifying factors that influence the force and occurrence of kickback.
Practical steps and techniques to prevent kickback situations.
Explanation of pushback and pull-in reactive forces encountered during cutting.
Methods to prevent pushback and pull-in during saw operation.
General precautions and steps before starting the chain saw.
Step-by-step guide for attaching the guide bar and saw chain.
Explanation of the chain brake system and its importance.
Instructions on how to manually engage and release the chain brake.
Correct fuel mixture ratios and recommended gasoline types for the saw.
Safe procedures for refueling the chain saw with fuel mixture.
How to check if the chain lubrication system is functioning correctly.
Step-by-step guide for starting a cold engine using the choke.
Procedure for starting a warm engine.
Instructions on how to properly shut down the engine.
Indicators that signal the need for chain sharpening.
Techniques and angles for correctly sharpening the saw chain.
General| Chain pitch | 3/8 \ |
|---|---|
| Blade length | 350 mm |
| Product color | Black, Orange, Stainless steel |
| Automatic oiling | Yes |
| Oil tank capacity | 0.28 L |
| Fuel tank capacity | 0.48 L |
| Engine displacement | 34.7 cm³ |
| Noise level | 110 dB |
| Vibration emission | 4.3 m/s² |
| Engine power | 2.3 hp |
| Power source | Gasoline |
To Next Page
