Dolmar MS290.4U - Manual feed type; BEFORE STARTING THE ENGINE; Basic information about engine oil

13 ENGLISH
4. Afterinstallingthenyloncuttinghead,removethe
hex wrench.
1
4
2
3
►1. Nylon cutting head 2.Receivewasher3. Shaft
4. Hex wrench
Manual feed type
1. Installthereceivewasherontotheshaft.
2. Insert the hex wrench through the hole in the gear
case.
3. Insert the nylon cutting head into the shaft and
tighten the nut.
4. Afterinstallingthenyloncuttinghead,removethe
hex wrench.
1
5
2
3
4
►1. Nut 2. Nylon cutting head 3.Receivewasher
4. Shaft 5. Hex wrench
Hex wrench storage
CAUTION: Be careful not to leave the hex
wrench inserted in the tool head. Doing so may
causeaninjuryand/ordamagetothetool.
When not in use, store the hex wrench as shown in the
guretokeepitfrombeinglost.
For bike handle model
1
2
►1. Knob 2. Hex wrench
For loop handle model
1
2
►1. Handle 2. Hex wrench
BEFORE STARTING THE
ENGINE
Basic information about engine oil
Recommended oil:
SAE10W-30oilofAPIClassication,ClassSFor
higher (4-stroke engine for automobile)
Oil volume:
Approx. 0.08 L