Dolphin DOL1000-MF - Programming Keypad Functions; Adding and Removing Access Codes; Setting Relay Output Time; Master Code Management

3 Programming Guide
Example:
STEP 1: Press 1
2 3 4
STEP 2: Press 1
#
STEP 3: Enter access code __ __ __ __
STEP 4: Press 1
# (multiple beeps confirm)
STEP 5: Press *
*
STEP 6: Test new access code. __ __ __ __ (Green light will flash 6
times confirming that the new access code has been accepted.)
STEP 8: Proceed to program the keypad to the receiver.
STEP 7: Install the module.
Add Access Codes
New Access Code
Channel
NOTE: Default Master Code:
1 2 3 4
1 2 3 4 1 # 1 #
1
Remove Access Codes
Access Code to Delete
1 2 3 4 2 # #
New Master Code
#
2
Use Channel 1 if unsure. The different channels are dependent on the RF
terminal used. Any channel can be assigned for devices that connect to
normally open/normally closed.
#
Set Relay Output Time
Seconds: 0-60
1 2 3 4 5 #
3
NOTE: This will clear all data except the Master Code.
Change Master Code
1 2 3 4 7 #
4
Clear All Codes
1 2 3 4 8 #
5