Need help?Do you have a question about the Dolphin dolkpl1kb and is the answer not in the manual?
Terminal 1-2 serves as the power input for the keypad.
Terminals 3-8 are for Output 1 and Output 2 relays (N.C., COM, N.O.).
Terminal 9 is the egress input, granting access when pressed.
Terminals 10-12 are for Output 3 relay or bell connection.
Terminal 14 provides a duress output, activated by a duress code.
Terminal 15 serves as the common ground connection.
Terminal 16 is the normally closed input for door position sensing.
Terminals 19-20 connect to the tamper switch (normally closed).
Details keypad tones and LED signals for various operational statuses.
Describes jumper settings for full or auto backlit illumination.
Procedure to enter programming mode if master code is forgotten.
Code and procedure to reset the keypad to factory defaults.
Covers entering programming, setting master codes, and managing user access.
Setting and clearing visitor codes for one-time or time-limited use.
Configuration of door unlock timer, toggle access, and safety settings.
Configuration for keypad sounds, including access confirmation beeps.
Settings for code entry modes and blinking yellow LED behavior.
Details on operating voltage, current, temperature, and humidity.
Information on working environment and ingress protection (IP-66).
Number of user PINs, duress codes, and visitor codes supported.
Details on code entry timing and programmable timers.
Configuration for egress button and definitions of input/output terminals.
Specifications for dry contact ratings of output relays and tamper switch.
To Next Page
General
