Auto/Manual Code Entry Settings
Auto Code
Entry Mode
7 01 #
The # key after entering
an access code will NOT
be required.
Important Note: For this
feature to work, ALL
codes must be the same
number of digits as the
master code. Ex. If the
Master Code is 6-digits,
all other codes must be
the 6 digits to enable Auto
Code Entry Mode.
Manual Code
Entry Mode
7 02 #
The # key after entering
an access code will be re-
quired but all codes may
vary in digit length.
Blinking Yellow LED Settings
Blinking Yellow
LED - On
7 31 #
The amber LED will blink
every 2 seconds during
functionality
Operating Voltage:
12V-24V DC, Auto adjusting
Operating Current:
40mA (quiescent) to 100mA (three relays active)
Operation Temperature:
-4 F to +158 F
Environmental Humidity:
5-95% relative humidity non-condensing
Working Environment & Ingress Protection:
All weather, IP-66
Number of Users:
Output 1 – 1,000 User PINs + 50 Duress Codes
Output 2 – 100 User PINs + 10 Duress Codes
Output 3 – 100 User PINs + 10 Duress Codes
Number of Visitor Codes:
50, programmable for one time or with the time limit
Timings for Code Entry:
10 seconds waiting for next digit entry
The Timers:
Three 1-99,999 Seconds (Over 24 Hours possible) Independent
Programmable Timers for O/P 1, 2 & 3
Specifications
5
To Next Page
Loading...
