Dolphin dolkpl1kb - Programming Chart; Programming Mode and Access Codes; Visitor Codes Management

Feature Code Entry
Comments
Begin
Programming
Mode (Solid
Yellow)
Master Code * *
Set System into Program-
ming Mode. The default
Master Code is 0000.
Note: All of the following
commands must be keyed
while in Programming
Mode.
End
Programming
Mode
* *
Return to normal
operation.
Set Master
Code
01 Master Code #
(4-8 digits)
Set your new Master
Code.
Access Codes
Record Access
Codes (Output
1, 2, 3)
Output Number 02
(1, 2, or 3)
User number
(000-999)
Access Code #
(4-8 digits)
Set 4-8 digit code for gen-
eral access. Each unique
4-8 digit code will require
a new user number. Note:
It is important to docu-
ment your user numbers
because users can be de-
leted and reassigned new
codes for access.
Delete Access
Codes (Output
1, 2, 3)
Output Number 05
(1, 2, or 3)
User number #
(000-999)
Delete the user and re-
move their Access Code.
Clear all Access
Codes
Output Number
(1, 2, or 3)
00999 #
Clear all Access Codes de-
pending on which output
relay accessed.
Visitor Codes (Output 1 only)
Set a Visitor
Code for one-
time use
40 Visitor number 00
(01-50)
Visitor Code #
(4-8 digits)
The Visitor Code can
only be used once until
cleared.
Set a Visitor
Code time limit
4 Visitor number
(01-50)
Hours Visitor Code
(01-99) (4-8 digits)...
The Visitor Code will be
cleared after the set time
limit.
Programming Chart
4