EasyManua.ls Logo

Dolphin DRC-1G - Trouble Shooting

Default Icon
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
6. TROUBLE SHOOTING
1) If the system does not work?
◎ Check the main breaker-ON in the control box.
◎ Check the ELB ON in the operation breaker.
◎ Check the power lamp-ON at Power s/w ON.
◎ Check the Ready lamp ON.
◎ Check the Main Electric power 380V (in case of 3 Phase 4 wired)
◎ Check the operating power 220V.
2) If not watering
◎ Check the power s/w lamp
◎ Check the watering valve open
◎ Check the 380V on main breaker
◎ Check the watering (solenoid) valve
◎ Check power on floatless sensor
◎ Check the lamp off after clean the sensor if floatless sensor lamp on.
3) If not quit watering
◎ Clean the floatless sensor
◎ Clean the solenoid valve
◎ Check the floatless sensor lamp on
4) If dish is not clean after wash
◎ Remove dregs at the wash nozzle
◎ Check the tripper up on wash contactor
◎ Remove the dregs in wash pump
◎ Check the leakage and short of wash pump
◎ Push the tripper after check wash pump
◎ Check 380V on wash pump contactor by voltage tester
◎ Check the water is full in wash tank, otherwise fill up the water into
the wash tank after its leakage.
◎ Check the wash temperature, 55℃~65℃
◎ Check the chemical agent feeding, automatically
◎ If lower temperature, check the temperature controller and contactor
5) If rinse is not good
◎ Check if the water pressure, 1.2Kg/㎠ over
◎ Clean dregs on the rinse nozzle
◎ Check rinse temperature, 82℃