Connecting the ENiQ and ELS Desk Reader or programming station
Connecting the ENiQ and ELS Desk Reader or
programming station
For connection of the ENiQ and ELS Desk Reader you will require a PC or
laptop with ENiQ access management software, ELS software or ELS mobile
software installed on it.
Proceed as follows to connect the ENiQ and ELS Desk Reader:
Insert the micro USB-B plug of the USB cable into the USB socket on the
desk reader.
Insert the USB plug of the USB cable into a free USB socket on the PC or
laptop.
The desk reader drivers are installed automatically and the desk reader will be
available for selection following successful installation in the software.
To Next Page
Loading...