Type 333K
This chapter describes the assembly of the cam with stud for the type 333K. Type KL
with knob must be assembled in the same way.
Requirements: 1 matching key, 1 cam (235855), 2 security rings (202335F) for the
cam, 1 security ring (202335F) for each extended side (optional), 1 stud axis (de-
pending on the length), 1 spiral pin (099434), 1 coupling (220895), 1 carrier plate
(220897F 002), 1 cone pin (236497) 1 compression spring (215230), 1 pliers
(261669) for the cam, 1 pliers (261669) for the extension piece (optional).
When mounting type KL with knob, you need the following:
1 cam (509293 008) and 1 stud axis (509393).
Caution! The cylinder core is not yet fixed by the security ring. If you in-
sert the key the core may be pulled out completely from body again and
the pins will fall out. In such an event core and body have to be com-
pletely re-filled.
Fig. 28: Insertion of cam
1. Please insert a proper key.
2. Please turn key gently.
3. Please pull out the cylinder core to
such an extent until the core or the
core extension piece provides a flush
fit internally with the cylinder body.
4. Please insert cam into the cylinder
body.
To Next Page
Loading...
