EasyManua.ls Logo

Dometic 2000 Series - Troubleshooting Guide

Dometic 2000 Series
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6

































1. Toilet emits odor (ush ball
open).
2. Water will not stay in bowl.
3. Flush ball will not close
completely.
a. Odor emitting from base of toilet.
b. Plugged holding tank vent line.
a. Loose band clamp.
b. Improper seal around ush ball
due to dirt or debris on ush ball.
c. Worn or damaged seal.
d. Worn or damaged ush ball.
a. Too much friction between ush
ball and seal.
b. Water valve screws are too tight.
c. Defective spring cartridge.
a. Use SeaLand brand deodorants.
b. Clear obstruction from vent line.
a. Tighten adjusting screw.
b. Inspect ush ball and seal for
foreign debris. Clean ush ball
and seal if needed.
c. Replace seal.
d. Replace ush ball.
a. Lubricate between ush ball and
seal with furniture polish (e.g.
Pledge
®
furniture polish).
b. Loosen screws slightly.
c. Check spring tension by pushing
ush lever down, then release it
suddenly. If lever does not snap
back to original position, replace
spring cartridge.
  
® Pledge is a registered trademark of S.C. Johnson & Son Inc.

Related product manuals