To Next PageTo Next Page
Need help?Do you have a question about the Dometic 630515.331 and is the answer not in the manual?
General| Brand | Dometic |
|---|---|
| Model | 630515.331 |
| Category | Air Conditioner |
| Language | English |
Explains the safety alert symbol and its meaning.
Defines signal words like WARNING and CAUTION for hazard levels.
States product features are subject to change without notice.
Details the intended installation and design for recreational vehicles.
Provides tips for reducing heat gain and improving AC performance.
Explains condensation causes and how to minimize it.
Lists essential safety guidelines for performing the installation safely.
Details factors to consider when selecting an installation site on an RV roof.
Outlines requirements for preparing the roof opening for the AC unit.
Specifies requirements for duct material, insulation, sealing, and design.
Discusses determining duct size, layout, and register placement for proper airflow.
Details routing and connection procedures for the 120 VAC power supply.
Outlines the routing and connection of the dedicated 12VDC supply line.
Details routing the 4-conductor control cable for the Comfort Control Center.
Guidelines for choosing the optimal location for the Comfort Control Center.
Instructions for routing and terminating the control cable.
Steps for physically mounting the Comfort Control Center unit.
Advises on safe lifting and handling of the approximately 100-pound unit.
Instructions for positioning the air conditioner unit over the roof opening.
Instructions for aligning the ceiling template with the roof opening.
Steps for installing the divider plate and preparing it for the AC unit.
Steps for placing the divider plate and ensuring a proper seal.
Instructions for applying self-adhesive insulation to the divider panel.
Specific instructions for installations without a center discharge duct.
Steps for installing the foam divider in the opening for specific kits.
Instructions for installations using a center discharge duct.
Details connecting various low voltage wires to the control box.
Emphasizes safety precautions for connecting the 120 volt AC power supply.
Instructions for installing the decorative inside cover for specific return air kits.
Instructions for installing the decorative inside cover for the Genesis system.
Explains how to set dip switches for equipment options and configurations.
Describes the procedure to reset the system after configuration changes.
Verifies that all system features and modes are functioning correctly.
Presents the electrical schematic for the 620515, 620525, and 620526 models.
Presents the electrical schematic for the 630515 and 630516 models.
