To Next PageTo Next Page
Need help?Do you have a question about the Dometic 630516.331 and is the answer not in the manual?
General| Cooling Capacity | 13, 500 BTU/h |
|---|---|
| BTU Cooling | 13, 500 BTU |
| Voltage | 115 V AC |
| Hertz | 60 Hz |
| Power Supply | 115V/60Hz |
Explains the safety-alert symbol and its meaning for personal injury.
Defines WARNING, CAUTION, and CAUTION (no symbol) signal words.
Specifies intended use and mounting for RVs.
Explains condensation and its prevention.
Lists safety warnings and compliance requirements before installation.
Discusses factors for selecting the best installation site on an RV.
Details required opening sizes for roof vents or new cuts.
Steps for removing existing roof vents and preparing the opening.
Instructions for cutting and framing a new roof opening.
Guidelines for designing and installing the air distribution system.
Details for routing and connecting the 120 VAC power supply.
Instructions for running the 12VDC supply line.
Routing requirements for the remote temperature sensor cable.
Routing requirements for furnace thermostat wires.
Routing for EMS load shed wires.
Routing the control cable for the Comfort Control Center.
Routing for additional control cables for multi-zone systems.
Routing for the AGS control cable.
Guidance on choosing the proper location for the Comfort Control Center.
Steps for routing and connecting the control cable.
Steps to mount the Comfort Control Center unit to the wall.
Steps for aligning and attaching the ceiling template.
Instructions for installing the divider plate based on ceiling thickness.
Steps for installing the Genesis system with non-center ducts.
Instructions for placing and securing the foam divider.
Steps for applying foam and installing the ceiling template.
Connects low voltage wires for various system components.
Connects the 120V AC power supply to the unit.
Steps for installing the inside cover for specific return air kits.
Steps for installing the inside cover for the Genesis system.
Setting dip switches for desired system options.
Steps to perform a system reset after configuration.
Verifies that all installed system features are working correctly.
