Operation CFX100W
18
➤ Before starting up the device for the first time, check whether the operating
voltage and the battery voltage correspond (see type plate).
➤ Run the extended wiring from DC cable in-vehicle connection point (4) to the
battery (6).
➤ Make sure that the cable to the positive (+) battery terminal is protected with an
additional 15 A fuse (5) close to the battery. Do not remove the fuse of the sup-
plied DC cable.
➤ Connect the supplied DC connection cable (2) to the in-vehicle connection
point (4).
➤ Plug the DC connection cable (2) into the DC voltage socket of the cooler (1).
CFX-100W--O-EN-AUS.book Seite 18 Donnerstag, 13. Juli 2017 10:12 10
To Next Page
Loading...
