Dometic Go Power! GP-SB-PWM-30BT - Battery and Temperature Faults; Setting Parameters

[page 16] | gopowersolar.com
Battery Over Voltage
The battery voltage is too high (if using a custom battery
type, the setting in menu 9 sets this point). User should
disconnect the battery and make sure it is rated for a 12V
nominal system. If yes, contact the battery manufacturer for
recommended next steps.
Charge Temperature Limits Violation
The battery temperature is outside of the acceptable range
of operating temperatures at the current charging rate. User
should make sure the ambient temperature is within accept
-
able range and/or disable charging to let the battery cool.
The GP-SB-PWM settings can be accessed by pressing and holding the ENTER button. Use the up ▲ and down ▼ keys to reach the Settings menu.
Enter the menu by pressing the ENTER button again.
4.3 SETTING PARAMETERS
The settings listed with values of 9 through 19 on pages 16 to 18 are relevant only to setting a custom battery type. They will only be visible if the
battery type setting number 1 is set to Custom.
The Custom Prole settings should ONLY be used by professional installers and advanced users.
Note
OPERATION