Dometic Go Power! GP-SB-PWM-30BT - 8. History Reset; 9-14. Voltage Setpoint Configuration

[page 18] | gopowersolar.com
8. History Reset
(YES / NO)
This resets the historical information in the solar controller. Use this if you want to
start collecting data from a known point in time.
9. Battery Overvoltage Setpoint
(8.0 to 16.0)
This setpoint will show a fault if the battery voltage is higher than the 8.0 to 16.0
value. Change this according to system requirements if you are using the custom
battery prole.
WARNING: DO NOT use it if you are unsure of how to properly set, or
consult a professional.
10. Equalization Voltage Setpoint
(8.0 to 16.0)
Sets the equalization voltage setpoint. Use this to set the value according to
system requirements if using the custom battery prole.
WARNING: DO NOT use it if you are unsure of how to properly set, or
consult a professional.
11. Absorption Voltage Setpoint
(8.0 to 16.0)
Sets the absorption voltage setpoint. Use this to set the value if using the custom
battery prole.
WARNING: DO NOT use it if you are unsure of how to properly set, or
consult a professional.
12. Float Voltage Setpoint
(8.0 to 16.0)
Sets the oat voltage setpoint. Use this to set the value if using the custom
battery prole.
WARNING: DO NOT use it if you are unsure of how to properly set, or
consult a professional.
13. Re-Absorb Voltage Setpoint
(8.0 to 16.0)
Sets the re-absorb setpoint. If the battery voltage falls below this threshold, the
controller will start a new charge cycle and perform an absorption. Use this to set
the value according to system requirements if using the custom battery prole.
WARNING: DO NOT use it if you are unsure of how to properly set, or
consult a professional.
14. Low Voltage Setpoint
(8.0 to 16.0)
This setpoint will indicate a low voltage fault. Someone would want to change
this according to system requirements if they are using the custom battery prole.
Use this to set the value according to system requirements if using the custom
battery prole.
WARNING: DO NOT use it if you are unsure of how to properly set, or
consult a professional.
OPERATION