Heki2 Using the Heki2
9
8Using the Heki2
8.1 Opening in the tilting position (fig. b)
➤ Press the latches on both rotary bolts and turn them 90° (A).
➤ Hold the bracket in the middle and move it out of the original position (B).
➤ Tilt it downwards.
➤ Push the glass dome upwards (C).
Opening the glass dome is supported by the two gas springs after approx.
150 mm.
➤ Swivel the bracket to the glass dome and press it back into the original
position (D).
To close it, follow the instructions in the reverse order.
8.2 Opening in the half-way position (fig. c)
➤ Press the latches on both rotary bolts and turn them 90° (A).
➤ Hold the bracket in the middle and move it out of the original position (B).
➤ Tilt it downwards.
➤ Push the glass dome upwards (C).
Opening the glass dome is supported by the two gas springs after approx.
150 mm.
➤ Open both the latches (D).
➤ Tilt the bracket to the half-way position.
➤ Pull the glass dome down until the bracket is lying in the holders.
➤ Secure the bracket with both latches.
To close it, follow the instructions in the reverse order.
Heki2-IO-16s.book Seite 9 Montag, 28. November 2016 8:56 20
To Next Page
Loading...
