Dometic POWER AWNING PRO - Pairing the 9100 Remote Control; Verifying the Remote Control Functions; Pairing the Wind Sensor (If Applicable)

10
EN
Pairing the Wind Sensor (If Applicable) Wireless Remote Control/Receiver & Wind Sensor
8.2 Pairing the 9100 Remote Control
This section describes how to pair the 9100 awning
series only.
I
Complete each pairing step within four seconds
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
Step Operation
Audible
Alert
Awning
Movement
1 None None
Remove the battery
cover from the back of
the remote.
2 None
Turn the receive
Power button ON.
Beep xl
3 None
Press the Le P2
button two times.
Beep x2
4
1
Press the Up button
one time.
Beep x4 Awning
jogs
5
1
Press the Le P2
button one time.
Beep x1 Awning
jogs
6
1
None
Press the Up button
one time.
Beep x1
Step Operation
Audible
Alert
Awning
Movement
7
1
None None
Press Down button
one time
8
1
Press Le P2 button
one time
Beep x1 Awning
jogs
9 Proceed immediately to “Verifying the Remote
Control Functions” on page10.
1
For 9100 awnings only: Steps 4-8 represent the One Touch programming
procedure.
8.3 Verifying the Remote Control
Functions
This section describes how to verify remote control
functionality aer pairing the remote control and the
receiver.
To verify remote control functionality:
1. Press the Down button. The awning should extend.
2. Press the Up button. The awning should retract.
If either button does not perform as expected, see
“Pairing the Remote Control” on page9 and
restart the pairing process.
3. Upon successful verification, proceed to “Pairing the
Wind Sensor (If Applicable)” on page10.
9 Pairing the Wind Sensor (If
Applicable)
NOTICE: Do not rely on the wind sensor to prevent
damage to the awning. The awning should always be
closed when unattended or when strong rain, wind, etc.
is expected.