Dometic POWER AWNING PRO - Adjusting the Wind Sensor Sensitivity; Clearing the Wind Sensor Memory; Vehicle Ignition Lock-out

12
EN
Vehicle Ignition Lock-out Wireless Remote Control/Receiver & Wind Sensor
9.2 Adjusting the Wind Sensor
Sensitivity
Once programmed, the sensitivity can be adjusted at
any time without reprogramming. The sensitivity of the
wind sensor can be set from 1 (most sensitive) to 9 (least
sensitive) with the sensor dial. Settings 0 and 5 are for
programming only and are not active settings.
9.3 Clearing the Wind Sensor
Memory
Step Operation
Audible
Alert
Awning
Movement
1 None None
Remove the battery
cover from the back of
the remote.
3 None None
Press the Le P2
button one time.
3 None None
Press the Stop button
one time.
4 None None
Press the Le P2
button one time.
10 Vehicle Ignition Lock-out
When a motorized RV’s ignition is in the ACC, ON, or
START position, a functioning receiver will automatically
retract/lock/cut power to the awning.
I
For motorized RVs only: Make sure the awning
automatically closes when starting the RV.
When the motorized RV’s ignition is in the OFF position,
the awning is unlocked and will operate normally.
START
OFF
OFF
ACC
ON
START
ACC
ON
q
w
10 Vehicle Ignition Lock-out
q
Ignition ON
w
Ignition OFF