4
EN
Intended Use Wireless Remote Control/Receiver & Wind Sensor
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV
technician for help.
Operation is subject to the following conditions:
• This device may not cause harmful interference.
• This device must accept any interference received,
including interference that may cause undesired
operation.
2 Intended Use
The Power Awning Pro system (hereinaer referred
to as “unit” or “product”) works with compatible RV
power awnings to offer remote control of the awning’s
opening and closing. This product is only suitable for the
intended purpose and application in accordance with
these instructions.
This manual provides information that is necessary for
proper installation and/or operation of the product.
Poor installation and/or improper operating or
maintenance will result in unsatisfactory performance
and a possible failure. The manufacturer accepts no
liability for any injury or damage to the product resulting
from:
• Incorrect assembly or connection, including excess
voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express permission
from the manufacturer
• Use for purposes other than those described in this
manual
Dometic reserves the right to change product
appearance and product specifications.
3 General Information
This section describes the awning series compatibility
and the recommended tools to install the receiver.
I
The images used in this document are for reference
purposes only. Components and component
locations may vary according to specific product
models. Measurements may vary ±0.38 in. (10 mm).
3.1 Tools and Materials
Dometic recommends that the following tools and
materials be used while installing the appliance.
Included Parts Part Number Quantity
12 V Wireless Receiver 3317114.201 1
Receiver Wire Harness
n/a
1
1
Remote Control with Wall
Holder and Screws
3316518.201 1
Dry Contact Power Switch
n/a
1
1
Dry Contact Switch Wire
Harness
n/a
1
1
Miscellaneous Wire
Connectors
n/a
1
9
Installation and Operation
Manual
3317118.000 1
1
Not applicable
Recommended Tools
#11 (0.191 in.) Drill Bit Needle Nose Pliers
7/16 in. Hex Nut Driver/Bit Phillips Screwdriver/Bit
Drill Riveting Tool
Flat-Bladed Screwdriver/Bit
(Small)
Wire Cutter
Optional Parts Part Number
Wind Sensor
1
Black (3316519.205)
White (3316519.202)
3/16” x 1/2” Pop Rivets
2
Installer-Supplied
1
Available as an accessory (not included).
2
Requires two for wind sensor option installation.
To Next Page
Loading...
