Dometic ProSafe MD283 - Page 15

EN
Using the safe proSafe
16
Changing R.E.O.S. code
A
You can change the factory-set R.E.O.S. code (210104). The safe must be locked for
this.
➤ Press the ENTER button twice.
➤ Enter the six digit R.E.O.S. code.
➤ Press the ENTER button.
✓ The display shows the message DELAY.
➤ Press the ENTER button.
➤ Enter a new six digit R.E.O.S. code within ten seconds.
➤ Press the ENTER button.
✓ The display shows the message REPEAT.
NOTICE!
• If you forget your R.E.O.S. code, nobody can access the safe any
more (not even the manufacturer). No resetting, or similar action, is
possible.
• Therefore note down the R.E.O.S. code and store it very carefully in
a safe location.
• The safe has a factory-set R.E.O.S.code. Change this code for secu-
rity reasons.
CURRENT
PIN 6X
ENTER
NEW
PIN 6X
ENTER
ENTER
NEW
PIN 6X
ENTER
ENTER
ENTER2X
DELAY
REPEAT
MD-IO-16s.book Seite 16 Freitag, 4. August 2017 9:25 09