RM122, RM123 Installing the refrigerator
17
➤ Press the knob of the temperature switch to the spindle so that it is fixed in the
recess.
➤ Stand the device upright.
➤ Wait a few hours before starting the refrigerator.
7.8 Changing decor panel
!
A
You can change the decor panel. The replacement door decor panel can consist of
stainless metal or plastic laminate and must have the following dimensions:
485x350x0.5–3mm (H x W x D).
To change the decor panel, follow the steps below:
➤ Turn the refrigerator on the side.
➤ Remove the three screws on the bottom of the door frame.
➤ Pull out the decor.
➤ Slide the new decor into the opening.
➤ Screw the three screws back in.
➤ Stand the refrigerator upright and connect the cables and gas source (see chap-
ter “Connecting the refrigerator” on page 18).
➤ Wait a few hours before starting the refrigerator.
WARNING! Risk of gas poisoning!
When breaking the gas line, gas could leak out.
In this case, let a certified gas engineer install and run a pressure check.
NOTICE! Risk of damage
Lay the refrigerator on the side only, never on the backside. Otherwise
the cooling pipes may be damaged.
rm122_rm123-EN.book Seite 17 Dienstag, 7. Februar 2017 9:00 09
To Next Page
Loading...
