nstallation as well as the connect flue oulets are to be
hecked every two years by an expert (this has to be
rranged by the person responsible).
ake sure that:
● The refrigerator is not operating on 12 V when the ve-
hicle is parked, otherwise you will drain the car battery in
a short time.
● Defrosting is carried out periodically.
● The refrigerator is clean and dry with the door left open
when it is not to be used for some time.
● Liquids or items with a strong odour are well packa-ged.
● The ventilation openings are unobstructed.
● The door is secured by means of the travel catch when
the caravan is on the move.
● Only one mode of operation at a time is used to run the
refrigerator.
he refrigerator is guaranteed for one full year on condition
hat it is used in a correct manner and in accordance with
hese operating and installation in-structions.
t is also embraced by a European guarantee as described
n the brochure supplied with the refrigerator.
ervice and spare parts are obtainable from your dealer or
DOMETIC - consult the yellow pages of the telephone
verall dimensions
Height (incl. controls) .............606mm
Width .........................486mm
Depth (incl. cooling unit)
without door..............440mm
with door.................480mm
uild-in dimensions
Height .........................610mm
Width .........................490mm
Depth .........................460mm
apacity
gross ............................60lit
net ............................51lit
frozen food compt.....................6lit
Weight (whithout packaging)......... 21kg
lectrical data
Input 230 V ..................... 105watt
12V ........................ 100watt
Energy consumption/24 hours .....2.3kWh
p gas data
Input (max) ..................... 186watt
ditto, low flame ................... 86watt
Energy consumption/24 hours
max......................0.35 kg
mid.......................0,24 kg
min.......................0.16 kg
ooling medium ..............Ammonia (R 717)
he door hinges can be moved to the opposite side in the
ollowing way:
● Unscrew the upper hinge pin, taking care not to lose the
set of washers and bushes.
● Lift the door from the lower hinge pin.
● Unscrew the pin and mount it on the opposite side hinge.
● Unscrew the travel catch and mount it on the opposite
side.
● Carefully prise out and exchange the plastic inserts in the
holes for the tarvel catch in the upper door frame. (fig.
10)
● Fit the door on the pin and reassemble the pin with
washers and bushes in its new position.
● Check that the door closes properly and seals all round.
he door panel can easily be mounted or changed. The
imensions of the panel must be:
Height .........................532mm
Width .........................453mm
Thickness....................max3,8mm
● Remove the door, see REPOSITIONING THE HINGES.
● Remove the lower trim moulding and then withdraw the
panel by sliding it downwards.
● Fit the new panel in place and slide it up as far as
possible.
● Fit the trim moulding back in place.
nstallation in open air applications.
Under an awning, on a veranda, etc.)
● Place the refrigerator protected from rain, direct sun
exposure and strong draught.
● The location should be cool and with good air circulation
to avoid concentration of the flue gases. The ventilation
opening at the top of the refrigerator must not be co-
vered.
● Place the refrigerator on a sturdy base so that it does not
tipp over when its door is opened.
● The base must be level. Check with a water level and
adjust if necessary.
he room should have a capacity (lenght x width x height)
f at least 20 m
3
and have a window (wich can be opened)
t is important that the refrigerator is not subject to heat
adiation from a stove etc.
10