Operation SC26, SCT26, SC30, SC30B, SC38
14
6.4 Using the cooler in AC mode
(only SC30, SC30B, SC38)
➤ Place the device on a firm base.
➤ Connect the AC cable to the AC mains supply.
➤ Turn the cooling capacity control (fig. 2 6, page 3) to the desired position.
➤ Push the cold/hot switch (fig. 2 5, page 3) to the position “Cold” (cooling) or
“Hot” (heating) to switch the device on.
✓ The device starts cooling/heating the interior.
6.5 Devide the interior (only SC38)
You can devide the interior of the refrigerator as follows (fig. 4, page 4):
• No partition grille (A): Both coolers are actively cooled or heated.
• Open partition grille (B): The large cooling compartment is actively cooled or
heated. The small cooling compartment is less cooled or heated.
• Closed partition grille (C): The big cooling compartment is actively cooled or
heated. The small refrigerator compartment is passively cooled or heated.
I
➤ Mount the partition grille as shown (fig. 5, page 5).
NOTE
Mount the bar, even if you operate the cooling device without partition
grille, so that the lids can close properly.
SC26-SCT26-SC30-SC38_OPM_EMEA16.book Seite 14 Mittwoch, 19. Juni 2019 8:51 20
To Next Page
Loading...
Need help?
General
