Operating the generator TEC60EV
14
Displays
8 Operating the generator
A
I
8.1 Basic notes on operation
!
Please note the following basic information:
• Always check the oil level before use (chapter “Checking the oil level” on
page 18).
• Even small overloads in the long-run will cause the generator to stop.
• Leave the generator running for a few minutes after use without any consumers
before stopping it.
No. in
fig. 3,
page 4
Description
6 AC supply Actual voltage output
7 Constant output Current capacity of connected consumer
8 Operating hours Time the generator is in operation
9 DC voltage Battery charging voltage
10 Messages Status reports of the generator (see chapter
“Display messages” on page 16)
NOTICE! Damage hazard
Do not run the generator over 70 % of the maximum constant output for
the first 50 operating hours (run-in phase).
NOTE
By doing this you can prolong the service life of the generator and
optimise its output:
run the generator at a maximum of approx. 75 % of the maximum
continuous load after the run-in phase.
CAUTION! Beware of injury
Do not insert your fingers or objects into the air nozzles or the intake
grille.
TEC60EV-O-16s.book Seite 14 Montag, 5. August 2019 12:56 12
To Next Page
Loading...
Need help?
General
