TEC60EV Operating the generator
17
LOW POWER ENGINE
The inverter supply voltage has
dropped.
The generator stops. Reduce the connected load and
start the generator again.
Overspeed
RPM too high
The generator stops. Press the button START/STOP to
restart the generator. If the prob-
lem persists, contact the manu-
facturer's branch office in your
country (see back page).
Start failed
Example: No fuel, cold tempera-
ture, spark plug to be replaced,
dirty air filter
The generator is switched off. Press the start button to restart
the generator.
GEN CAL
Message appears when the gen-
erator is started up; it shows the
calibration phase which takes
place before each start-up. The
generator does not supply any
voltage.
The generator is running but
does not supply any voltage.
Wait a moment.
GEN WAIT
Message appears while you are
waiting for the generator to start
again.
The generator is switched off. Wait until the message has disap-
peared then attempt ignition
again.
GEN ON
The generator is operating
normally.
Normal mode –
GEN OFF
The generator is idle and can be
started.
–
GEN Stop
The generator is stopped. Wait a moment.
Wait Cooling
The engine is running without
load to cool down the system.
Wait a moment.
Inverter lost comm
The generator stops. Check the system by referring to
the troubleshooting table.
If the problem persists, contact
the manufacturer's branch office
in your country (see back page).
Display message
Description
Generator behaviour Measures
TEC60EV-O-16s.book Seite 17 Montag, 5. August 2019 12:56 12
To Next Page
Loading...
Need help?
General
