TEC29 EV AUS Operating the generator
33
10.3 Switching the digital control panel on and off
This switch (fig. 4 2, page 4) on the digital control panel is for switching the
digital control panel on and off.
➤ Switch the digital control panel on with the on/off switch.
✓ The display shows:
GEN OFF.
The display switches off automatically after 5 minutes if the start button is
not touched within this time.
Press and hold the start button for 4 s to switch on the display again.
✓ The generator can now be started.
10.4 Starting the generator
The generator can only be started if it is in standby and the digital control
panel is switched on.
➤ Start up the generator by pressing the start/stop button (fig. 4 3,
page 4).
10.5 Stopping the generator
➤ Stop the generator by pressing the start/stop button (fig. 4 3, page 4).
If the generator does not stop: switch it off by pressing the red on/off
button or by pressing the main switch (fig. 3 1, page 4) on the internal
control panel.
To Next Page
Loading...
