TEC29 EV AUS Servicing the generator
41
12.4 Changing the oil
!
A
You may use the following oil:
API SG or SF grade oil for four-stroke engines.
SAE 10W-30 grade oil (can be used at any temperature).
Oil with single grade oil viscosity.
Select the appropriate viscosity according to the average temperature on-
site.
Change the oil as follows (fig. k, page 12):
➤ Allow the generator to run until warm so that the oil can drain off faster and
completely.
➤ Place a suitable receptacle under the drain plug (1).
➤ Take out the drain plug (1).
✓ The oil drains off.
➤ Pour fresh oil into the nozzle.
The amount of oil is: 0.6 l.
CAUTION!
Hot oil can cause burns.
NOTICE!
Only dispose of used oil at a specialist recycling station and
observe the local laws for environmental protection.
To Next Page
Loading...
