Servicing the generator TEC29 EV AUS
40
12.2 Preparing maintenance work
!
➤ Switch the generator to the off position with the main switch (fig. i 1,
page 11).
➤ Disconnect the positive terminal of the supply battery.
➤ Open the generator front door.
For maintenance work, you can take the generator out (fig. j, page 12):
!
➤ Undo the fastening screws (1).
➤ Remove the mounting plate (2) with the generator from the housing (3).
12.3 Finishing maintenance work
➤ Connect the generator to the positive terminal of the supply battery.
➤ Switch the generator to standby with the main switch (fig. i 1, page 11).
➤ Close the generator front door.
CAUTION!
Note the following for all maintenance work:
The generator must not be running.
All the parts must be cooled down.
WARNING!
The mounting plate with generator is very heavy (> 40 kg) and
could fall out the housing if you take it out too far.
To Next Page
Loading...
