TEC29 EV AUS Operating the generator
35
GEN CAL
Message appears when the
generator is started up; it
shows the calibration phase
which takes place before
each start-up. The generator
does not supply any voltage.
The generator is running but
does not supply any voltage.
Wait a moment.
GEN WAIT
Message appears while you
are waiting for the generator
to start again.
The generator is switched off. Wait until the message has
disappeared then attempt
ignition again.
GEN ON
The generator is operating
normally.
Normal mode –
GEN OFF
The generator is in stand-by
and can be started.
–
ENABLE AUTOSTART [HOLD]
CONFIRM
Message appears when the
automatic mode is switched
on.
Controls are waiting for user
input
Press the start button within
15 seconds and hold down
for 4 seconds.
GEN AUTO
Automatic mode
The automatic mode is
switched on
–
COOLING
The generator keeps on run-
ning but the inverter is off.
Wait until the unit cools down;
the generator will automati-
cally turn off.
Display message
Description
Generator behaviour Measures
To Next Page
Loading...
