TEC29 EV AUS Operating the generator
37
10.8 Switching to automatic mode
You can only switch to automatic mode:
if it was configured when the generator was installed (see chapter
“Connecting the autostart wiring” on page 31
if the vehicle is stationary and the ignition is switched off
In automatic mode, the generator switches on automatically and charges the
battery if the voltage of the connected battery is too low.
The generator switches off automatically once the battery has been fully
charged.
The generator can also be turned ON/OFF using a remote switch (not
provided) as indicated in fig. h, page 11.
To switch on the automatic mode:
➤ Switch on the automatic mode switch (if available).
➤ Switch the ignition off.
➤ Switch the digital control panel on by pressing the on/off switch.
✓ The display shows:
ENABLE AUTOSTART [HOLD] CONFIRM
I
➤ Press the start button within 15 seconds and hold it down for 4 seconds.
✓ The display shows:
GEN AUTO.
➤ The automatic mode is switched on.
NOTE
If
GEN OFF appears on the display instead of ENABLE AUTOSTART
[HOLD] CONFIRM
, the automatic mode is not configured for your gen-
erator. If this is the case, contact the specialist workshop which
installed the generator and have the automatic mode retrofitted.
To Next Page
Loading...
