EPT076596 Issue 1 – March 2022
22
Volt free input
This configuration requires the Black & Red cores of the
signal cable (see section 1 for location) to be connected
together, in order to start the extractor. When the 2 cables
are connected together the motor will start and maintain
the set flow rate (see section 5.4 for how to set the flow)
when the 2 cables are disconnected the motor will slow
down and come to a stop. The extractor will need to be
turned on and be out of standby mode (See section 5.1 for
turning the extractor on) in order for this feature to operate.
Changing the language
The system has five programable languages :
• English (Default)
• Spanish
• French
• German
• Portuguese
Once the language has been selected it will automatically
change the system, no restarts are necessary.
Information
The ‘Information Page’ will display system information.
• iQ2 PCB serial number
• Software versions
• Logging information
To access the information, see the following icons:
Support
The ‘Support’ page will display contact information for
technical and sales support, to access the support page see
the following icons:
OR
To Next Page
Loading...
