EasyManua.ls Logo

Donaldson Torit Downflo Evolution DFEP4 - Product Service; Dust Bin Service

Donaldson Torit Downflo Evolution DFEP4
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
During any service activities there is some potential for exposure to the dust in the collector. Most dusts present safety
and health hazards that require precautions. Wear eye, respiratory, head, and other protection equipment suitable for
the type of dust when performing any service activities..
LOCK-OUT all energy sources prior to performing any service or maintenance on the equipment. The E-Stop feature
of the DFEP Control is NOT a Lock-Out device.
Dust Bin Service
The dust bin should be emptied daily or more frequently as required.
1. Turn off collector.
2. If equippped with a Delta P Plus/Delta P-C01 controller, ensure the downtime cleaning cycle has ended.
3. Open the dust bin access door by rotating the two handles counter clockwise.
4. Reach in and lift the dust bin locking bar up until the bar clears the top of the bin. This should lower the dust bin to the ground.
5. Roll the dust bin from under the collector hopper.
6. Transfer dust from the dust bin to a suitable disposal site. A liner may be used in the dust bin and dust can then be transferred
from the dust bin for suitable disposal using the liner. (A vacuum is not required or recommended for servicing the bin.)
a. For the extended capacity dust bin, remove the bag liner retention bar.
b. Close and seal the bag liner.
c. Lift the bag liner from the dust bin and properly dispose of sealed bag liner and dust.
d. Install a fresh bag liner in dust bin.
e. For the extended capacity dust bin, replace bag liner retention bar.
7. Inspect the area around the dust bin and remove any spilled dust.
If a vacuum is used to remove dust from below the hopper, make certain it is suitable for the type of dust and the
operator is trained in its operation.
8. Inspect and clean the hopper discharge gasket surface. Replace gasket if worn or damaged.
9. With the locking bar up, align and insert the dust bin under the collection hopper until it contacts the mechanical stops on the
hopper assembly.
10. Lower dust bin locking bar to its down and locked position.
11. Close and latch dust bin access door by rotating the two handles clockwise.
4 Product Service

Related product manuals