STERILIZATION
1. Reassemble the machine back into its original state. Plug
machine into power source and power machine back on.
Fill hopper with water just above the freezing cylinder and
augers. Press the MIX buon to acvate the rotaon of the
augers.
2. Add 1 tablespoon of sodium hypochlorite (liquid Bleach) into
the water inside of the bowls. Let the auger mix the water
and bleach combinaon and soak for about 10-20 minutes.
Drain the water and power down the machine when com-
plete.
7. Remove the faceplate by rotang the 2 thumb bolts on both
sides of the faceplate counter clockwise.
8. Remove the auger by simple pulling it straight out of the
freezing cylinder. Handwash all parts connected to the face-
plate and auger using soap and water.
9. Using a warm wet cloth, wipe down the freezing cylinders
and the hopper to remove any residual residue.
10. Once all parts are clean, assemble the faceplate and mount
it back on to the front of the D150.
To Next Page
Loading...