DONPER D150 - Cleaning Machine

Cleaning Your Machine
1. Make sure you have placed your D150 into standby mode by
taking it out of so serve mode or out of Slush mode.
2. Press the "CLEAN" buon on the control panel to acvate
the auger.
3. Pull down on the dispensing handle to empty out all of the
contents from inside the freezing cylinder and hopper then
release the handle back into its closed posion.
4. Pour clean water into the hopper on your D150, then repeat
step 3 in order to empty out all of the water and residual
contents of the mix.
5. Connue with steps 3 & 4 unl the water that in being dis-
pensed from the machine begins to come back fairly clear.
6. Once the water that is being dispensed from the D150 is fair-
ly clear coming out of the machine, drain all of the water
from the D150 completely and then press the "CLEAN" but-
ton again and this will shut o the auger and put the ma-
chine back into standby mode.
Power down and unplug the power cord from the power source before you continuing.