DONPER D150 - Adjusting the Settings; Firmness Setting; Soft Serve and Hopper Settings

Adjusting the Settings
To access the SETTINGS and make adjustments to them each seng, you
will rst need to access standby mode. To do so, simply make sure your
machine is plugged into its main source of power. Locate the Main Power
switch on the back of the machine and switch it into the ON posion. Your
machine is now in stand by mode. Follow the instrucons below to make
adjustments for each of the sengs.
While in standby mode, press the “UP” and “DOWN” buons simultane-
ously for 5 seconds and “SET” will begin ashing on the display panel and
the number on the right side of the display panel will go into the rst set-
ng, P1. Press the “SET” buon to scroll through the sengs below.
FIRMNESS SETTING
Press and hold the "UP" or "DOWN" buon for about 2 seconds
and the word “SET” will begin to ash on the display panel. Press
“UP” or “DOWN” to increase or decrease the hardness seng.
The range of the hardness seng is from 1 to 10, 1 being the
soest seng and 10 being the rmer seng.
SOFT SERVE AND HOPPER SETTINGS
P1 - Preset Temperature for Hopper Cooling
Press “SET” buon to enter the P1 seng, press “UP” or “DOWN”
to adjust the temperature from -9°C to 9°C, press “SET” buon
again to save the data and enter into the P2 seng.