DONPER D150 - Hopper Cooling

HOPPER COOLING
1. Press the “HOPPER COOLING” buon to acvate the Cooling
Feature for the Hopper.
2. The screen will now display the current temperature of the
hopper on the right side. The hopper will connue to cool
unl the temperature of the hopper reaches the Preset Tem-
perature for Hopper Cooling.
3. The hopper will begin cooling again once the temperature of
the hopper reaches the set Return Temperature for Hopper
Cooling.
4. Pressing the “HOPPER COOLING” buon again will de-ac-
vate the Hopper Cooling feature.
This funcon only can be acvated when the machine has been placed in
either So Serve Mode or in Slush Mode.
3. Press the "SLUSH" buon to enter into the slush mode. The
current temperature of the freezing cyclinder will display on
the le side of the screen, and the preset Target Temperature
is displayed on the right.
4. The mix will begin freezing inside of the freezing cylinder un-
l the temperature of the freezing cylinder (displayed on the
LEFT) reaches the preset Target Temperature (displayed on
the RIGHT) plus 5 minutes.
Note: The 5 minutes in which the compressor continues to run after the target tem-
perature is reached, only happens when the mix in your machine is warmer than 0˚C.