[CHAPTER 5 OPERATION]
5-4 |
DOOCHPUMP
5.2 Function Setup
5.2.1 Basic Function Setup
It is a basic parameter setup to operate the drive. Any parameter that is not set by the user,
it is set default value of factory setting.
1) Common Setup
It is a parameter setup to set and confirm commonly when controlling pump using drive
regardless to type of control.
Setup Item
Parameter
Code
Description on Function
Input Location of Run
Command
dr-01
To select a method to issue Run command
(FND, Terminal Block)
Input Method of Target
Frequency
dr-02
To select a method to control target operation
frequency (Own PID, FND, V1, I1)
Capacity of Motor dr-10 To set up Capacity of Motor
No. of Poles of Motor dr-11 To set up No. of Poles of Motor
Rated Current of Motor dr-12 To set up Rated Current of Motor
Rated Rotations of Motor dr-13 To set up Rated Rotations of Motor
Rated Voltage of Motor dr-14 To set up Rated Voltage of Motor
No-load Current of Motor dr-15 To set up No-load Current of Motor
Rated Slip Frequency of
Motor
dr-16 To set up Rated Slip Frequency of Motor
Rated Frequency of
Motor
dr-17 To set up Rated Frequency of Motor
Efficiency of Motor dr-18 To set up Efficiency of Motor
Rotation Direction
Selection of Motor
dr-20
To set up Rotation Direction Selection of
Motor Properly
Stopping Method of Motor dr-21
To set up Stopping Method of Motor to stop
the motor
Increase/Decrease Time dr-22/dr-23 To set up Increase/Decrease Time of Drive
To Next Page
Loading...
