dooch Q-Drive NQ-0750-T - Function Setup: Pump Control and Expansion

[CHAPTER 5 OPERATION]
5-6 |
DOOCHPUMP
Setup Item
Parameter
Code
Description on Function
CAN Comm. Mode Pr-50 To set up CAN Comm. Mode
CAN Comm. ID Pr-51
To set up CAN Comm. ID
(If ID is ‘0’, CAN Comm. is disabled.)
CAN Comm. Speed Pr-52 To set up CAN Comm. Speed
5.2.2 Expansion Function Setup
It is to set up parameters to operate pump system optimally except for those to be set for
operating the drive. Any parameter that is not set by the user, it is set default value of factory
setting.
1) Pump Control Parameters
Setup Item Parameter Code Description on Function
PID Controller Gain
Setup
Pr-07~09
To set up gain to adjust response
characteristics of PID controller
Control Cycle of PID
Controller
Pr-10
To set up Control Cycle of PID Controller
Start Pressure
Variation
Pr-12
Minimum pressure variance to allow drive to
start
Initial Output Ratio on
Starting
Pr-15
To set up initial starting output frequency of PID
controller in order to speed up response against
initial starting
Lead Pump
Alternation
Pr-53~54
To operate pump alternatively in force during
multi-drive operation