dooch Q-Drive NQ-0750-T - Drive Control Group

[CHAPTER 6 FUNCTION TABLE & DESCRIPTION]
Pr-90 Initialization Code
ㆍ It carries out initialization with factory settings.
Setup Data Functional Description
0 (Factory Setting) To maintain settings (Factory Setting)
To initialize with factory settings 1
Pr-92 S/W Version
ㆍ It displays program version.
6-4-2 Drive Control Group
dr-00 Jump Code
ㆍ It allows moving to desired code number directly.
ㆍ It is also possible to move to other code using key after moving.
dr-01 Command Input Location Setup
ㆍ It sets operation command location.
When selecting FND key, it is possible to issue operation command using key on main body of
drive. When setting up terminal block, it is possible to issue operation command using external
input(P1)
Setup Data Functional Description
0 (Factory Setting) Operation Command with FND
Operation Command with Terminal Block(P1) 1
6-15 | DOOCHPUMP
Pr-86 Deletion of Fault History
ㆍ It deletes all of the fault history
Setup Data Functional Description
To maintain error contents(Factory Setting) 0
To delete all of error contents 1
Pr-87 Sensor percentage
ㆍIt corrects sensor by % unit.
ㆍIn order to decrease sensor value, enter smaller value than 100 based on 100% while in order to
increase it, enter larger value than 100.