4.1.3 Dial-Out Phone Numbers
To use the dial-out phone number feature, the guest simply presses a two-digit directory code (24-50)
on the system keypad. The 1812 will automatically dial out the phone number programmed under the
directory code that was entered on the keypad (section 2.3.1). Once the call is answered, the person
called may grant access by pressing the programmed tone open number or they can press the hang
up number (2.2.10) to disconnect the call without granting access.
4.1.4 Access Codes
The access codes will operate either relay 1 or relay 2 depending on which relay they have been
programmed to activate (section 2.4.1 and 2.4.2). Access codes may also be time zone restricted
(section 2.5.6). To use an access code, you must press the # key first. When a valid access code is
entered, a long tone will sound indicating that the relay has activated.
1. Press # then enter the access code [# _ _ _ _ _ (beeeeeep)]
When the access code is entered on the keypad, the system will check its memory to see if the code
is programmed to activate relay 1 or relay 2, and will also check any time zone restrictions that may
have been programmed for the specific code that was entered.
If the access code is a temporary code, the system will check the clock/calendar to determine if the
current day falls within the programmed temporary access code boundaries (section 2.4.5).
Page 40 1812-161-E-1-10
To Next Page
Loading...
