Operation Section
123
Typical Example of ASC-204
NOTE: In ASC-204 factory-setting controller,
automatic mode is selected for both
direction inhibit and two-speed auto shift
control as a default on the PCB(Printed
Circuit Board).In ASC-202 factory-setting
controller, manual mode(Fail-Safe Mode) is
selected as a default for direction inhibit
while automatic mode is selected as a
default for two-speed auto shift control.
7. Replace the Controller cover plate and screws.
8. Turn ON the electrical disconnect switch, if
equipped.
9. Start engine. check the Controller LED indication
for "A". For indications other than "A", see
following section on Fault Diagnosis.
NOTE: After operating the truck manually by
selecting the Manual Mode switch on
PCB(Printed Circuit Board), the position of
mode must be checked before operating the
truck automatically.
To Next Page
