Maintenance Section
169
6. Remove the dip stick/filter cap. Fill the drive axle
housing with oil. See "Lubricant Specification -
Drive Axle Oil" and "Refill Capacity".
7. Start the lift truck. With the engine at low idle,
place the directional control lever to the
NEUTRAL.
8. Maintain the oil level between lower mark and
upper mark on the dip stick/filter cap.
9. Install the dip stick/filter cap.
Parking Brake - Test, Adjust
WARNING
To prevent personal injury, the operator must be
ready to use the service brake if the parking
brake is not adjusted correctly and the lift truck
starts to move.
NOTE: Be sure area around the lift truck is clear of
personnel and obstructions.
1. Drive the lift truck with a rated load up a 15%
incline.
2. Halfway up the incline, stop the lift truck by
applying the service brakes.
Typical Example
3. Engage the parking brake and slowly release the
service brake.
4. If the parking brake has the correct adjustment
the lift truck will be hold in place. If the parking
brake does not hold, adjust the parking brake.
To Next Page
