Below are abbreviations that may appear on the
Identification, Lift Capacity and Attachment Plate
and their meanings.
Mast Abbreviations
STD -
Standard Mast
(single inner member, low free lift)
FF -
Full Free Lift Mast
(single inner member with high free lift
duplex cylinder)
FFT -
Triple Lift Mast (two inner members) with
either low or full free lift characteristics.
QUAD Quadruple (Quad) Mast(with three inner
members)
NOTE: When only a mast-type is listed on the
identification plate, a standard carriage and
forks are used.
Attachment Abbreviations
(includes Special Forks)
SC-
Special Carriage-increased width,
height or outreach
SSS -
Shaft-type Sideshift Carriage
HSS -
Hook-type Sideshift Carriage (ITA)
CW -
Counterweight
SF -
Special Forks
SWS -
Swing Shift, Sideshift
RAM -
Ram or Boom
DBCBH
-
Double Cube Block Handler
HFP -
Hydraulic Fork Positioner
CR -
Crane Arm or Crane Boom
TH -
Tire Handler
CTH -
Container Handler
LPP -
Load Push-Pull Device
CC -
Carton Clamp
RC -
Roll Clamp
LS -
Load Stabilizer
PWH -
Pulp Wood Handler
SS-ST -
Sideshift-Side Tilt Carriage
To Next Page
