Instrument Panel
1. Engine Ignition Start Switch
The key switch is a four position
switch. Position (1) is
ACCESSORY ON. Position (2) is
OFF. Position (3) is ON or RUN
and accessory ON.
Position (4) is START, which
engages the starter.
After the key has been turned to the START position,
the key must be returned to the OFF position before
it can be turned to the START position again.
2. Engine Coolant Gauge
Indicates coolant temperature. If
the pointer moves beyond the
green band while operating the
lift truck, overheating is indicated.
Park the lift truck and stop the
engine.
Check the cooling system for a
malfunction. The point will be at the end of the green
band when the coolant temperature reaches
approximately 103°C(217°F) on all engines.
3. Transmission Oil Temperature Gauge
Indicates transmission oil
temperature. If the pointer moves
beyond the green band while
operating the lift truck, excessive
transmission oil temperature is
indicated. Park the lift truck and
stop the engine
Check the system for a
malfunction. The pointer will be at the end of the
green band when the transmission oil temperature
reaches approximately 120°C (248°F).
4. Fuel Level Gauge
Indicates fuel level in the fuel
tank.
5. Hour Counter
Indicates the total number of
hours the engine and the lift
truck have operated. The hour
meter will operate when the
ignition switch is in the ON
position, whether the engine is
running or not.
The hour meter is used to determine lubrication and
maintenance intervals.
6. Speed meter
Indicates the truck travelling
speed(km/h).
7. Turn Signal Lever
This is the lever to indicate the
turning direction of the lift truck.
As this lever is maneuvered, the
signal lamp blinks.
8. Horn Switch
To give alarm to fellow worker(s)
around and in the path of your
truck, press the rubber at the
center of the handwheel.
WARNING
Don’t run the truck while the alarm is sounding.
It is dangerous to do so, since poor effect is
expected.
R
To Next Page
