Starting From a 24/12 Volt External
Source
WARNING
Sparks occurring near the battery could cause
vapors to explode.
Always connect the external power source
ground cable to a point away from and below the
battery, and well clear of fuel system
components.
Typical Example Diesel Engine Truck
Typical Example LP Engine Truck
NOTICE
Do not reverse battery cables. It can cause damage
to the alternator.
Always connect the external power source cables in
parallel with the lift truck battery cables :
POSITIVE(+) to POSITIVE(+) and NEGATIVE(-) to
NEGATIVE(-).
Attach ground cable last, remove first.
All lift trucks equipped with DOOSAN built internal
combustion engines are NEGATIVE(-) ground.
Starting with Jumper Cables
WARNING
Batteries give off flammable fumes that can
explode.
Prevent sparks near the batteries. They could
cause vapors to explode. Do not allow jump
cable ends to contact each other or the lift truck.
Do not smoke when checking battery electrolyte
levels.
Electrolyte is an acid and can cause personal
injury if it contacts skin or eyes.
Always wear eye protection when starting a lift
truck with jump cables.
Improper jump procedures can cause an
explosion resulting in personal injury.
Always connect battery positive (+) to battery
positive (+) and battery negative (-) to be battery
negative (-).
Jump only with a battery source and with the
same voltage as the stalled lift truck.
Turn off all lights and accessories on the stalled
lift truck. Otherwise, they will operate when the
jump source is connected.
NOTICE
When starting from another machine, make sure the
machines Do not touch. This could prevent damage
to engine bearings and electrical circuits.
Turn on (close) the disconnect switch prior to the
boost connection to prevent damage to electrical
components on the stalled machine.
Severely discharged maintenance free batteries
might not fully recharge by the alternator alone after
jump starting.
The batteries must be charged to the proper voltage
by the battery charger.
Many batteries thought to be unusable, are still
rechargeable.
This machine has a 24 volt starting system. Use
only equal voltage for jump starting. Use of a welder
or higher voltage equipment will damage the
electrical system.
To Next Page
Loading...
